Bio - Age Equipment & Services

Highlights:

• Type 1 ,Type-II & Type - 3 Water in a Single Integrated System.
• Three stage Integrated pretreatment module of 10μ/5μ/1μ/0.5μ/iron filter, activated carbon, antiscalant,enough to protect and enhance the life of the precious cartridges
• High recovery upto 60% of water with Polyamide T.F.C. membrane double R.O. Pass.
• Most economical Ultra pure grade water cost per liter as compared to other systems available in the market.

Feed Water Specifications: Potable Tap water with pressure  0.5 kg to 1.5 Kg (1-6 bar or better),Conductivity: upto 2000µS/cm, Chlorine:<3ppm, SDI <12, TOC<2000ppb, CO2: < 50ppm, Silica  <30ppm, Temperature: 4 to 40 Degree C,  Flow rate: up to 75 L/hr, Drain: > 90L/hr, System  include Pre-Filtration Cartridge (1,5 & 10 µ ) with Booster Pump and 01 Bio filter (point-of-use Biofilter of 0.2micron) to remove residual biologically active contaminants

Specifications:

Highlights:

• Single stage pre-filteration setup of 10µ/5µ/1µ to protect and enhance the life of the RO cartridges.
• Better substitute to Quartz/ Glass Single/ Double** Distillation Apparatus, TDS is zero.
• Easy quick fit connectors to exchange filter/module of the water purification system.
• Very Low Electricity consumption as compared to conventional distillation apparatus, low maintenance.
• Saves potable water from tap up to100L/hr VS distillation units.
• High recovery rate>30% of double RO Pass
• No Scaling problem as compared to Distillation.
• Saves Water as compared to conventional distillation method.
• Rapid and simple disinfection.

 

Specifications:

* Feed Water TOC <250ppb

** Depends upon feed water conductivity <300µS/cm

Additional Information:

• Production Capacity: 5/10/15/20 LPH

Highlights:

• Single stage pre-filteration setup of 10µ/5µ/1µ to protect and enhance the life of the RO cartridges
• Better substitute to Quartz/ Glass Single/ Double** Distillation Apparatus, TDS is zero.
• Easy quick fit connectors to exchange filter/module
• Very Low Electricity consumption as compared to conventional distillation apparatus, low maintenance.
• Saves potable water from tap up to100L/hr VS distillation units
• High recovery rate>30% of double RO Pass
• No Scaling problem as compared to Distillation Saves Water as compared to conventional distillation method. Rapid and simple disinfection

 

Specifications:

 

* Feed Water TOC <250ppb

** Depends upon feed water conductivity <300µS/cm

Additional Information:

• Production Capacity: 5LPH / 10LPH

Highlights:

• Integrated table top/wall mounted sleek lab water system.
• Produces Type-I water and TDS is Zero.
• Lowest initial investment towards the cost of the system.
• Three stage pre-filteration of10µ/5µ/1µ/0.5µ, Flowrate:50LPH Feed Water: RO/DI water.

 

Specifications:

*1-2ppb with Dual UV Lamp,pH:7/Neutral with online measurement,Turbidity in NTU of Ultra Pure water:0.04
ELEMENTAL ANALYSIS(ppb):
Fe,Cu,Al,Ni,Zn,Cr,Na,K,Cl,NO₂,NO₃,SO₄:<0.005

Additional Information:

• Production Capacity: Up to 2L/minute

Highlights:

• Single stage pre-filteration setup of 10µ/5µ/1µ to protect and enhance the life of the RO cartridges
• Better substitute to Quartz/ Glass Single/ Double** Distillation Apparatus, TDS is zero.
• Easy quick fit connectors to exchange filter/module
• Very Low Electricity consumption as compared to conventional distillation apparatus, low maintenance.
• Saves potable water from tap up to100L/hr VS distillation units
• High recovery rate>30% of double RO Pass
• No Scaling problem as compared to Distillation Saves Water as compared to conventional distillation method. Rapid and simple disinfection

 

Specifications:

* Feed Water TOC <250ppb

** Depends upon feed water conductivity <300µS/cm

Additional Information:

• Production Capacity: 5/10/15/20 LPH

Highlights:

• Three Stage pre-filteration setup of 10µ/5µ/1µ/0.5µ/iron filter, activated carbon to protect and enhance the life of the precious cartridges.
• Low initial investment while buying the water purification system.
• High flux thin film composite (TFC) polyamide RO membranes.
• EDI’s continuous self regeneration process improves water quality.

 

Specifications:

*only if online UV in the system and feed water TOC <250ppb
* 1-2ppb with dual UV,pH:7/Neutral with online measurement,Turbidity in NTU of Pure Water<0.04

Highlights:

• Three stage Integrated pretreatment module of 10µ/5µ/1µ/0.5µ/iron filter, activated carbon, antiscalant,enough to protect and enhance the life of the precious cartridges.
• High recovery upto 60% of water with polyamide T.F.C.membrane double RO Pass.
• Ionic and Organic Rejection/Removal: >99%.

Feed Water Specifications: Potable Tap water with pressure  0.5 kg to 1.5 Kg (1-6 bar or better),Conductivity: upto 2000µS/cm, Chlorine:<3ppm, SDI <12, TOC<2000ppb, CO2: < 50ppm, Silica  <30ppm, Temperature: 4 to 40 Degree C,  Flow rate: up to 75 L/hr, Drain: > 90L/hr, System  include Pre-Filtration Cartridge (1,5 & 10 µ ) with Booster Pump and 01 Bio filter (point-of-use Biofilter of 0.2micron) to remove residual biologically active contaminants

Specifications:

Additional Information:

• Production Capacity: 5/10/15/20/25/30/35/40/50 LPH

Highlights:

• High recovery upto 55% of water with TFC polyamide R.O. module.
• Type-I Water in a Single compact bench top/wall mounting system.
• Ultra Pure Water directly from tap water
• Prefil-I/Prefill-III stage pre filtration setup.

 

Specifications:

Additional Information:

• Production Capacity: 5/10/15/20LPH

Our Direct Ultra Series of water purification systems offers an economical Type-I (Ultrapure grade), Type III (Lab grade) water in a single integrated table top/wall mounted sleek unit.

Highlights:

• High recovery upto 60% of water with Polyamide T.F.C. membrane double RO Pass
• Three Stage pre-filteration of 10µ/5µ/1µ/0.5µ,Iron filter, activated carbon,antiscalant. enough to protect and enhance the life of the precious cartridges
• Most economical ultrapure grade water purification cost per liter as compared to other systems available in the market.
• High quality T.F.C.Polyamide RO membrane >200 Dalton cutoff, Ion Rejection: >99%.

Feed Water Specifications: Potable Tap water with pressure  0.5 kg to 1.5 Kg (1-6 bar or better),Conductivity: upto 2000µS/cm, Chlorine:<3ppm, SDI <12, TOC<2000ppb, CO2: < 50ppm, Silica  <30ppm, Temperature: 4 to 40 Degree C,  System  include Pre-Filtration Cartridge (1,5 & 10 µ ) with Booster Pump and 01 Bio filter (point-of-use Biofilter of 0.2micron) to remove residual biologically active contaminants

Specifications:

Additional Information:

• Production Capacity: 5/10/15/20/25/30/35/40/50 LPH

*Feed Water TOC <250ppb

Product Quality: Type-III Clinical Grade Water
FEED WATER REQUIREMENT:
Conductivity:<500μS/cm
Temperature:<50°C
Fouling Index:upto12
Coaxial Conductivity Cell
MOC:SS316L
OTHER SPECIFICATIONS:
Controller:Microprocessor based microcontroller with Keypads
Supply:230V±10%,50Hz,AC
Consumption:60W/Hr
Weight:10Kg(approx)
Dimensions:535mm(H),330mm(W),280mm(D)
ACCESSORIES:

• Single Stage Prefiltration
• Storage Tank 10L with Vent filter and Level Sensors
• Power Cord
• Instruction Manual

OPTIONAL ACCESSORIES:

• UV with 254nm wavelength
• Storage Tank 20/50L capacity with Vent Filter
• EPF 0.20μ with filling bell having 260 cm² EFA
• High Flow Rate Models on Demand

*only if online UV incorporated in the system & feed water TOC <250ppb
* 1-2ppb with dual UV,pH:7/Neutral with online measuremnet,Turbidity in NTU for Pure Water<0.04.

Product Quality: Type II

Product Recovery: >55%

FEED WATER REQUIREMENTS:

Pressure:0.5Kg-1.5Kg(7.11psi-21.3psi)

Conductivity upto 2000µS/cm

Temperature:<50°C

Chlorine:<0.5ppm

CO₂:<50ppm

Fouling Index(SDI):upto 12

Auto Flushing: Every time system is switched on it goes for flushing mode to drain out all the contamination grown inside the stagnant water in cartridges/membranes.

Flushing Time: Customized, can be repeated or cancelled by pressing excape mode button.

Cleaning of R.O. Membrane: Automatic by flushing mode.

Safety Functions: Low/high pressure protection to R.O. module by switching off the supply to R.O. pump.

Cartridge R.O. Exchange Alarm: System gives audio/visual alarm to replace the cartrtidges with leftover time display.

R.O. Exchange Alarm: Audio/visual alarm for low rejecting R.O. cartridge with system switch off.

Tank: Fitted with Multiple/Three level switches & vent filter to synchronize with system to operate it automatically. System switches on/off according to level of water in tank.

R.O. Pump:System incorporates low noise,high pressure R.O. Pump with temperature feedback.

StandBy Mode: Recirculation loop at standby position(each hour repeatedly) to maintain the water quality and cartridges life in good condition.
Systems available without storage tank and UV in it.
Water storage tanks above 50L available on demand.
Pressure Tanks of 12/16/50L available on demand.
OTHER SPECIFICATIONS:
Microprocessor based microcontroller
Coaxial Conductivity Cell
R.O.membrane with 100-200Dalton cutoff with 95-99% rejection
Inbuilt Data storage for 1year can be transferred to PC,GLP Compliant.
Supply:230V±10%,50Hz,AC
Consumption:60W/Hr
Wt:25Kgs(approx)
Dimensions:550mm(H),420mm(W),505mm(D)
ACCESSORIES:

• Prefil-III set of Cartridge & Pressure Gauge R.O. module
• Initial cartridge set
• Storage Tank 20-50L Polycarbonate/PP/HDPE with 0.22μ vent filter,high/low level sensors
• Power cord
• Instruction manual

Additional Information:

• Pay Mode Terms: L/C (Letter of Credit),T/T (Bank Transfer),Other